Torsion Testing Machine 200Nm Torstion Test for Metal Nonmetal
This series torsion testing machine is mainly used for performing
torsion test on metal, nonmetal and compound materials
Standard: ASTM A938
This test method describes the torsion (or twist) testing of
The values stated in U.S. customary units are to be regarded as the
standard. The SI equivalents of U.S. customary units may be
This standard does not purport to address all of the safety
concerns, if any, associated with its use. It is the
responsibility of the user of this standard to establish
appropriate safety and health practices and determine the
applicability of regulatory limitations prior to use.
This International standard specifies a method for determining the
ability of metallic wire of diameter or characteristic dimension
0.1mm to 10mm inclusive to undergo plastic deformation during
simple torsion in one direction.
1. WANCE offers a full range of torsion testing machines in
capacities from 50 to 3000 Nm.
2. The weighing head with its strain gage torque sensor is mounted
on a moveable unit, which can position on the rails to accommodate
specimens of varying lengths.
3. This series belong to bench top with floor based and are
furnished with heavy duty slotted steel bed rails that are normally
lies on the test bed, the standing support bed and the slotted
steel rail are solid integral frame. These sliding rollers allow
the moveable unit to compensate for any changes in specimen length
4. All torsion testers feature our patented bi-directional grips,
which assure slip-free specimen clamping regardless of the twist
direction. With these precision-machined universal grips, loads can
be applied in both directions without changing grips.
5. Professional test software carries out closed loop control and
torsion test data analysis and capturing, and also showing the
material behavior throughout the test.
|Max torque (Nm)||200|
|Torque range (Nm)||2-200|
|Calibration Accuracy||Class 1 / Class 0.5|
|Torque accuracy||±1%(Class 1)/ ±0.5%(class 0.5)|
|Torque resolution(Nm)||1/500000 of max torque|
|Torsion angle (°)||0-10000|
|Torsion angle accuracy||±1.0%|
|Resolution of torsion angle between gauge length (°)||0.0045|
|accuracy of torsion angle between gauge length||±1.0%|
|Speed (°/min)||6 -720|
|Speed accuracy||±1.0% of set speed|
|Distance between clamping grips (mm)||650|
|Specimen diameter between gauge length (mm)||Φ6-Φ20|
|Motor Power (Kw)||1|
|Power requirements||220±10%VAC /50Hz|